A top climber or a climbing frame is used for this process. It fits between the top of the tower and the slewing unit. How To Disassemble a Tower Crane?
Before you begin to disassemble your tower crane, there are two different ways that it can be used. One: external, where the tower crane expands upwards on the outside of the building. Two: internally, generally erected inside the elevator shaft while the structure is built around it. Our Followers. With over 40 years of industry experience, All Lifting offers a total solution to lifting, rigging and height safety products and services. View cart. How is a Tower Crane Erected? Tower Crane Parts There are a number of different types of cranes but they generally are made up of Mast: the main tower of the crane, made out of steel trusses Slew: the slew is located at the top of the mast, this is what allows the crane to rotate How Are Cranes Constructed On Skyscrapers?
Explained simply: A weight is hung from the jib to balance the counterweight The slewing unit is detached from the top of the mast. Hydraulic machinery in the top climber pushes the slewing unit up The crane is lifted up by the crane another mast section into the gap that has been opened up by the climbing frame Once lifted it is bolted into place and a whole tower section taller How To Disassemble a Tower Crane?
Simply reverse the process to disassemble. It will essentially disassemble itself. Filed in: construction , crane , Cranes , franna , Tower Cranes. Previous article Synthetic vs Wire Winchline Rope. About Us With over 40 years of industry experience, All Lifting offers a total solution to lifting, rigging and height safety products and services. The Mast Section is is plumbed to a degree of ie It must not deviate more than 1 inch from plumb for every inches vertical.
Concrete is poured and then the crane is ready to be erected after the curing of the concrete. By comparison, the lug nuts on most cars torque to ft lbs. The process continues as mast sections are added until the needed height is achieved. The turntable operator cabin included is added in the same manner and is often the heaviest piece of the crane.
In some applications this section is split to reduce weight on the mobile crane. This may add two hours to the crane erection process, so it is avoided when possible. After the Turntable is installed the Tower Top is added and four large pins are added as the connecting members. The Counter Jib is erected as one piece.
It is connected by large gates or pins at the turntable. After this connection is made it is elevated by the mobile crane to around 15 degrees above horizontal. The pendants are connected by pins with cotter pins. Then the Counter Jib is lowered to horizontal. After this, any needed Erection Ballast is installed in the Counter Jib. The Working Jib of the crane is installed at the turntable and elevated with the Mobile Crane.
After it is elevated the Tower Crane hoist is connected to the pendant attached to the jib and pulled up to the Tower Top and connected with a pin.
Then the Jib is lowered back to horizontal. The installation of the Outer Section of the Jib is installed with the installation of three pins. Finally the Ballast up to 60, lbs is installed on the Counter Jib and the structural erection of the tower crane is complete. In most cases this end of the first day. To make the crane operational, the ropes must be installed on the crane.
0コメント